|
|
|
|
 |
 |
|
 |
Rota-Spray’
Etch/ Developer
|
 |
PCB Production Lines Complete 7 Tank Processing Lines
These units are very similar to the Labstations shown opposite but they include an extra spray wash and process tank. This enables the complete processing sequence to be undertaken in one compact free standing unit. Each tank is moulded from polypropylene. The 10" x 12" tanks from a single injection moulding and the larger 12" x 18" from two injection moulded tanks welded together and reinforced. All tanks have bottom drains so no syphoning is needed when the tanks are emptied. The cabinet itself is of a steel construction clad with polypropylene sheeting and incorporates a lockable storage facility. Doors are manufactured from 6mm thick black PVC. Both the PB710 for 10" x 12" boards and the PB720 12" x 18" boards are available with or without a sink fitted. The above illustration features a unit with a sink. A chemical starter kit is available which offers a saving on chemicals purchased separately. Order 2 kits for a 12"x18" unit. Dimensions |
 |
PA310
Tri-Tank Unit Develop, Wash and Etch Our best selling and most popular PCB processing unit. A self-contained triple process unit with built-in DEVELOP / SPRAY WASH / BUBBLE ETCH functions providing a convenient bench standing system. The PA310 eliminates the normal untidiness associated with producing PCBs to the solderable-etched stage. A RESIST STRIP / SPRAY WASH / IMMERSE TIN combination can be added to provide a full PCB processing run. Function tanks and splash proof controls are as standard, with all electrics brought together on the recessed front panel. The connections are provided at the rear for drain and cold water requirements. Complete with IEC socket, 2 metre mains cable with moulded 13 amp plug and two syphons. Width 400mm, Depth 525mm, Height 380mm. |
| PA107 Universal Develop, Strip or Tin |
PA210 Two-Tank Unit Etch and Wash |
PA103 Spray Wash |
 Complete with thermostatically controlled heater to cover PCB chemical temperature range of 10°C to 55°C. The tank can be thus selected for DEVELOP (25°C), RESIST STRIP (45°C) or IMMERSE TIN (21°C). Neons indicate when the mains heater is operative. Supplied complete with a syphon, IEC socket and 2 metre mains cable with moulded 13 amp plug. Width 180mm, Depth 525mm, Height 380mm. |
 An improvement over a standard Bubble Etch Tank. This unit is the same as the PA104 Bubble Etch Tank with the addition of an integral spray wash tank. The spray wash is solenoid operated and all electrical controls are on the front panel. Connections are provided at the rear for drain and cold water requirements. The integral spray wash tank offers safer and more efficient etching of boards than a standard bubble etch tank and being wider also gives greater stability. Complete with an IEC socket and supplied with 2 metres mains cable with moulded 13 amp plug and a syphon. Width 275mm, Depth 525mm, Height 380mm. |
 This tank contains two spray wash bars at the top, driven from a single mains water inlet, between which the developed, etched stripped or tinned board can be suspended to be rinsed. A bottom tube permits used water to be run off to waste. Width 180mm, Depth 525mm, Height 380mm. |
 |
Delight Supply
Co.,Ltd. 128/109 Phayathai Plaza Building 9th Floor, Phayathai Road,
Thung-Phayathai, Radthavee, Bangkok 10400, Thailand |